097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 95
Chapter 2 TL1 Command Syntax and Description
Retrieve Craft Data (RTRV-CRAFT)
imccomm Indicates if a communication alarm from the IMC to the IOC2(1) module is active
IMC1(2)COMM-OK – no IMC1(2)COMM alarm is currently active
IMC1(2)COMM-ALM – an IMC1(2)COMM alarm is currently active
iocstate The service mode of the IOC module.
INSERV | OOSRV
iocmode Indicates if the IOC module is active.
ACTIVE | STANDBY
clkmode The current mode of the local oscillator on the IOC module.
WARMUP | FREERUN | FASTLOCK | BRIDGING | HOLDOVER | LOCKED
clktype The assumed SSM quality level for the IOC module’s clock.
ST3E | TYPEI | ST2 | TYPEIII
<aid> = GPS
gpsstatus The current status of the GPS.
OK | ALM
instate The state of the GPS input.
ENABLE | DISABLE | MONITOR
qlevel The provisioned quality level for the GPS input.
1 | 2 | ... | 9
priority The provisioned priority level for the GPS input.
1 | 2 | 3 | 4
utc Universal Coordinated Time setting.
The format is HH:MM:SS, where HH is the hour in 24-hour format, MM is the minutes,
and SS is the seconds.
mode The user-specified position mode.
AUTO | MANUAL
pos The antenna latitude, longitude, and height setting.
The format is dd-mm-ss.ss (N or S), dd-mm.ss.ss (E or W), +/- hhhh.hh, where dd is
degrees, mm is minutes, ss.ss is fractional minutes, and hhhh is altitude in meters.
elevmask The current elevation mask, in degrees.
5 | 6 | ... | 45
<aid> = PRS
prsstatus The current status of the PRS.
OK | ALM
instate The state of the PRS input.
ENABLE | DISABLE | MONITOR
qlevel The provisioned quality level for the PRS input.
1 | 2 | ... | 9
Table 2-16. RTRV-CRAFT Output Fields (Continued)
Field Description
To Next Page
Loading...
Need help?
General
