CHAPTER THREE
B. TRANSLATOR FUNCTION CONTROLS
//L300 Translate IRIG B
//L306 Translate IRIG A
//L30L Translate IRIG G
//L312 Translate IRIG E - 100
//L318 Translate IRIG E - 1K
//L31n Translate IRIG H - 100
//L324 Translate IRIG H - 1K
//L32j Translate IRIG C - 100
//L330 Translate IRIG C - 1K
//L33L Translate 2137/ANGSQ53 – 1K
//L342 Translate NASA 36
//L34n Translate NASA 28 - 100
//L354 Translate 1892
//L35j Translate XR3/ANGSQ53-250
//L700 Normal Code Polarity
//L799 Inverted Code Polarity
//L800 Select AC Code translate
//L840 Select DC Code Translate
//L220 Select forward direction
//L201 Select reverse direction
//L221 Select Auto direction
//kL41 (Carrier filter on, Envelope filter off)
//kL81 (Envelope filter on, carrier filter off)
//kLL1 (Both filters on)
//kL01 (Both filters off)
3.11.7 PROGRAMMING THE TAPE SEARCH CONTROL OPTION
The TM7000 can be programmed to automatically search for any number of Tape Search
Intervals up to a maximum of ten. In the following command sequences, the letter “X”
represents an ASCII number character in the range of 0 to 9, which is the number of the Tape
Search Interval of interest The subscripted letters each represent a single ASCII numeric
character (e.g., D
H
= hundred’s of days).
3-32 TM7000 TymMachine TCG/T (Rev D) Symmetricom, Inc.