OPERATION
H. TRANSPORT CONTROL PARAMETERS
//jk00 Motion Control = Continuous;
Motion (e.g., Fast) First; Speed = Continuous
//jk10 Motion Control = Continuous;
Motion First; Speed = Momentary
//jk20 Motion Control = Continuous;
Direction (e.g., Fwd) First; Speed = Continuous
//jk30 Motion Control = Continuous;
Direction First, Speed = Momentary
//jk40 Motion Control = Momentary;
Motion First; Speed = Continuous
//jk50 Motion Control = Momentary;
Motion First; Speed = Momentary
//jk60 Motion Control = Momentary;
Direction First; Speed = Continuous
//jk70 Motion Contro l= Momentary;
Direction First; Speed = Momentary
3.11.8 PROGRAMMING TIME OUTPUT REQUESTS
A. TIME OUTPUT REQUEST
//komn Generator Time Word Output
//komo Translator Time Word Output
Time is output as either a string of ASCII characters or as Packed-BCD characters.
Please see Figures One and Two for the output format definitions.
3.11.9 PROGRAMMING STATUS OUTPUT REQUESTS
Each status requests returns a single 8-bit character (byte). In order to use this feature, the
TM7000 Series must be set up for 8-bit characters (not 7-bit characters), since the status byte
requires 8 bits. The numeric status is in a packed-BCD format, which means that each four bits
of a byte contain one BCD digit.
Symmetricom, Inc. TM7000 TymMachine TCG/T (Rev D) 3-35
To Next Page
Loading...
Need help?
General