Synrad Firestar f series - Page 103

technical reference
335
Synrad Firestar f-Series operator’s manual
f400 general specications
Parameter Firestar f400
Cooling Specications
Maximum Heat Load ............................................8000 Watts (27.3 kBtu/hr)
Flow Rate (minimum) .........................................4.0 GPM at < 60 PSI (15.1 lpm at < 414 kPa)
(recommended) ................................5.0 GPM at < 60 PSI (18.9 lpm at < 414 kPa)
Pressure Drop ..........................................................6 PSI at 4 GPM (41 kPa at 15.1 lpm)
Coolant Temperature
8
..........................................18 °C to 22 °C
Environmental Specications
Operating Temperature
9
.....................................15 °C to 40 °C
Humidity ...................................................................0–95%, non-condensing
Physical Specications
Length .......................................................................53.5 in (135.9 cm)
Width .........................................................................17.5 in (44.5 cm)
Height ........................................................................7.03 in (17.8 cm)
Weight .......................................................................170 lbs (77.1 kg)
* Specications subject to change without notice.
8 Firestar f400 lasers can be operated at coolant temperatures up to 28 °C (82 °F) in order to reduce problems associated with
condensation; however, this may result in decreased laser performance and/or reduced laser lifetime.
9 Published specications guaranteed at a cooling temperature of 22 °C.