Takeuchi TB 250 - Cautions on Starting the Hydraulic Pump; Installing the Hydraulic Pump

4-10
4
DRIVE SYSTEM
DISASSEMBLY AND ASSEMBLY
1. Remove the canopy or the cab.
“Removing the cab”
2. Remove the engine hood and the engine cover.
“Removing the covers”
3. Drain the oil from the hydraulic oil tank.
“Removing the hydraulic tank”
4. Disconnect the electrical wires from the solenoid valve
(5).
5. Disconnect the suction hoses from the hydraulic
pump.
6. Disconnect the discharge hoses from the hydraulic
pump.
7. Disconnect the hoses from the solenoid valve.
8. Remove the fixing bolts, and then remove the hydraulic
pump (2).
Apply molybdenum disulfide grease to the spline
Bolt: 102 N·m
Installing the hydraulic pump
For installation of the hydraulic pump, follow the same pro-
cedure as for removal in the reverse order.
Cautions on starting the hydraulic pump
1. Fill the pump housing with hydraulic oil before starting.
• Loosen the air-bleeding plug (4), and tighten it again
when oil starts to flow out from the hole.
2. After starting, let the engine run in low idle for a while to
bleed all air from the circuit.