4-42
4
ATTACHMENTS
DISASSEMBLY AND ASSEMBLY
Removing the boom
Lower the front end of the boom fully to the ground.
1. Disconnect the hydraulic hoses (1) from the arm cylin-
der (2).
2. Suspend the arm cylinder (2) temporarily, pull out the
pin (3) and then remove the arm cylinder.
Arm cylinder: 33 kg
3. Take out the clamp from the boom (4), and then dis-
connect
the hydraulic hoses (5) from the boom cylinder
(6).
4. Suspend the boom cylinder (6) temporarily and remove
the pin (7).
• Lower the boom so that the side where the cylinder
rod was removed touches the ground.
5. Disconnect the boom light wiring.
6. Disconnect the hydraulic hoses (8) from the pipe.
7. Suspend the boom (4) temporarily, pull out the pin (9)
and then remove the boom.
Boom: 192 kg
Installing the boom
For installation of the boom, follow the same procedure as
for removal in the reverse order.
To Next Page
Loading...
