4-61
4
HYDRAULIC PUMP
DISASSEMBLY AND ASSEMBLY
Assembly
1. Assemble the swash plate section.
a. Install the swash plate on the housing.
b. Install the bearing (11).
c. Install the distance piece (10).
d. Install the O-ring on the plate (9).
e. Install the plate (9) and secure it with cap screws.
Cap screw: 12 to 15 N·m
2. Assemble the shaft section.
a. Install the bearing on the shaft using the jig B.
• Use the bearing as a bed and press fit the shaft
using a press or a plastic hammer.
b. Install the snap ring and secure the bearing.
3. Install the shaft on the housing.
• Lightly tap the spring tip with a plastic hammer and
make sure that the outer ring of the bearing is se-
cur
ely fitted in the housing hole.
4. Install the O-ring.
To Next Page
Loading...
Need help?
General
