4-122
4
SOLENOID VALVE (1-SECTION)
DISASSEMBLY AND ASSEMBLY
Disassembly
1. Take out the cap screws and remove the solenoid coil
(1).
• Place alignment marks on the solenoid and the body
for easy reassembly.
• Take care not to let the push rod drop out.
Cap screw: 4.9 N·m
2. Remove the O-ring from the solenoid coil (1).
3. Remove the plug (2), and then remove the O-ring from
the plug (2).
Plug: 23.5 N·m
4. Remove the spring (4) and the spool (3) from the
body.
• Note down the positions of the spool and the body
hole so that they can be installed in the positions
they were in before disassembly.
Assembly
For assembly, follow the same procedure as for disassem-
bly in the reverse order by referring to the construction dia-
gram.
To Next Page
Loading...
