4-172
4
SLEW MOTOR
DISASSEMBLY AND ASSEMBLY
13. Install the spring seats (16) and the disc spring (15) on
the housing.
14.
Install the O-ring (14) on the housing.
15. Install the pin (8), bearing (6) and O-ring (7) on the cov-
er
.
Apply grease to the pin beforehand.
16. Install the pin (5) and the valve plate (4) on the cover
Apply grease on the back of the valve plate (the
side facing the cover) in advance to prevent the
plate from dropping out.
17. Install the cover (3) on the housing and secure it with
cap screws.
• Make sure that the pin and the valve plate are not
dropping out.
Cap screw: 128 ±7 N·m
To Next Page
Loading...
