Supervisor Functions Model: EV8650
Page 38 of 62 TP05413002 Rev. 03
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
Note: When pressing the DENOM key to exit the Supervisor Functions, you will be asked
to save the configuration (SAVE CFG). Should you not wish to save the configuration,
press the DENOM key to exit, or use the left or right arrow keys to select from further
options:
1. rESt CG - Which will reset the machine to the last saved configuration.
2. dEFLt CFG - Which will restore the machine back to ‘factory’ defaults.
Press the START/STOP key to accept.
CnS SEL Select communications settings. Select options using the
arrow keys; move on to next communication setting using the
START/STOP key. Press the DENOM key to exit: an option to
SAVE will be given (START/STOP key to confirm, DENOM
key to exit without saving).
Channel 1 (1 Ch_) can be set for 2650 Pro; 2620 Pro; Print
Pro; and 8643 Pro.
Channel 2 (2 Ch_) can be set for Print Pro; and rdiSP Pro.
3
rEStr SEL Specify the recovery settings. Options are Auto rec, on, oFF,
and rEStr.
4
bEEp oFF Switch on/ oFF the keypad beeper. 5
rdiSP SEL Remote Display time out period settings 6
Curr SEL To enable or disable currency tables for the operator 7
Supervisor Functions (Continued)
Mode Description Shortcut
To Next Page
Loading...
