Model: EV8650 Supervisor Functions
TP05413002 Rev. 03 Page 47 of 62
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
4.2.7 StAc (Change Stacker Limit)
Once in Supervisor Mode, use the Left and Right arrow keys to scroll through the
available Supervisor Functions.
Once StAc SEL is displayed, press the START/STOP key to enter that function or press
the DENOM key to exit. Press DENOM again to exit Supervisor Function completely.
Alternatively, in the Model EV8650, 12 supervisor functions have a short cut key which
can be used to select the functions directly (see ”Supervisor Functions Summary”
on page 37).
Specify stack limit.
The count display will show the current stack limit.
The limit can be changed within the range of 50 - 200 by pressing the left or right arrow
keys, or by entering the required limit using the numeric keypad.
The stack limit must be greater than the Batch limit, if trying to batch over 100 notes in
one count. The stacker limit is a maximum of 200 notes.
To exit the Stac function press the DENOM key.
To exit the Supervisor Functions completely, press the DENOM Key. You will be asked if
you want to save the settings.
Press the DENOM key to exit without saving.
Press the START/STOP key to save settings.
1. Display 7. Speed
2. Total 8. Det
3. Mode 9. Clear
4. Batch 10. Right Arrow
5. Start / Stop 11. Denomination
6. Auto 12. Left Arrow
13. Numeric Keypad
1
2
5
67
3
8
4
912 101113
To Next Page
Loading...
