Supervisor Functions Model: EV8650
Page 56 of 62 TP05413002 Rev. 03
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
4.2.13 rdiSP (Remote Display Settings)
Remote Display time out settings
Once in Supervisor Mode, use the Left and Right arrow keys to scroll through the
available Supervisor Functions.
Once rdiSP SEL oFF is displayed, press the START/STOP key to enter that function or
press the DENOM key to exit. Press DENOM again to exit Supervisor Function
completely.
The factory default is ‘0’ this means that the remote display will retain the last transaction
value until it has been either cleared by the user or a new transaction has been started.
The supervisor can set a time-out period on the display, so that after a preset period of
time the display will go blank.
The remote display time-out setting will be shown as:-
0rdS When the remote display time-out is disabled.
xx rdS When the remote display time-out is set to xx seconds.
Where xx can be set between 10 to 60 seconds
Use the numeric keypad to enter the time-out period you require.
Remote Display Error Display Function
The remote display can be set to show the CF and dEn error messages.
To activate this function, in the rdiSP SEL function press the MODE key, the display will
show rdSEr off, to turn error display on press the START/STOP key.
The screen will change to rdSEr on.
To return to the supervisor menu press the DENOM key
To exit the rdiSP option and the Supervisor Functions completely, press the DENOM
Key. You will be asked if you want to save the settings.
Press the DENOM key to exit without saving.
Press the START/STOP key to save settings.
1. Display 7. Speed
2. Total 8. Det
3. Mode 9. Clear
4. Batch 10. Right Arrow
5. Start / Stop 11. Denomination
6. Auto 12. Left Arrow
13. Numeric Keypad
1
2
5
67
3
8
4
912 101113
To Next Page
Loading...
