Model: EV8650 Supervisor Functions
TP05413002 Rev. 03 Page 57 of 62
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
4.2.14 Curr (To Enable Or Disable Currency Tables)
Once in Supervisor Mode, use the Left and Right arrow keys to scroll through the
available Supervisor Functions.
Once Curr_SEL is displayed, press the START/STOP key to enter that function or press
the DENOM key to exit. Press DENOM again to exit Supervisor Function completely.
Up to ten currencies tables can be installed on the machine, (depending on the detector
version) The super visor may only want too enable currency tables that the operator will
use.
The supervisor can enable or disable a currency table as follows:-.
The display will first show the status of the Currency Off option.
Use the START/STOP key to toggle between off and on.
C_oFF on When Currency Off is enabled.
C_oFF oFF When Currency Off is disabled.
Use the arrow keys to scroll through the installed currencies, indicated by they ISO code.
(Eur for Europe, USd for US Dollars and gbp for British Pounds.)
C_Eur on When the Eur currency is enabled.
C_Eur oFF When the Eur currency is disabled
If you have disabled a currency, it will not appear on the display when selecting a
currency using the DENOM Key, in normal operating mode
To exit the Curr option and the Supervisor Functions completely, press the DENOM
Key. You will be asked if you want to save the settings.
Press the DENOM key to exit without saving.
Press the START/STOP key to save settings.
1. Display 7. Speed
2. Total 8. Det
3. Mode 9. Clear
4. Batch 10. Right Arrow
5. Start / Stop 11. Denomination
6. Auto 12. Left Arrow
13. Numeric Keypad
1
2
5
67
3
8
4
912 101113
To Next Page
Loading...
