GEN. INSTR.
M5GENIN
Rev 1.0 Page 4
9. MEMORY CARD SLOT
Load and stores programs into the M5000. Makes
transfer of "personal" programs from one M5000 to
another very easy by means of the “credit card"-like
memory card.
10. VIEWING ANGLE
Makes the alphanumeric display readable at almost
any angle.
11. PAGE BUTTONS
As there are more parameters to edit than possible to
show at the same time the page buttons scrolls
through the parameters on the display.
12. SOFT DIALS A, B, C, D
Used for editing the parameter values on the display
just above.
13. PROGRAM DIAL
Turn this dial to preview the programs. Also used
when recalling, storing and renaming programs. The
top line on the display shows the current algorithm
type. The bottom line shows the name of the
program.
14. DO, UNDO BUTTONS
When operating the M5000 many functions will not
be executed until DO is pressed, e.g. turning the
program dial will not execute the program until DO
is pressed. The UNDO button enables you to com-
pare edited program with the original.
15. PROGRAM BUTTON
Press this button to select program source, store or
rename programs.
16. EDIT BUTTON
Press this button to edit the parameters in the current
program. As soon as a stored program is edited the
small 'edited' LED in the program number display
will be lit until it is stored again.
17. UTILITY BUTTON
The UTILITY mode enables the user to access
various utility menus for setting the selected kit.
18. BYPASS BUTTON
Press this button to bypass the current kit controlled
by the mainframe, corresponding to the selected
devices (
2
).
To Next Page
Loading...
Need help?
General
