MIDI & SMPTE
M5MIDIIN
Rev 1.4 Page 4
MIDI CONTROLLERS
The M5000 allows you to control any parameter of any algorithm with a fixed set of
controllers.
A MIDI controller is essentially a knob (such as a modulation wheel) which goes smoothly
from 0 (min.) to 127 (max.). Real-time MIDI control allows you to control a given parameter
(e.g. REVERB MIX, OUTPUT LEVEL, REVERB DECAY etc.) with a controller. In the
following, each parameter of each algorithm is listed with the associated controller#.
Since MIDI controllers always go from 0 to 127, they are scaled to fit with the associated
parameter. 0 represents the lowest possible value of the parameter, while 127 represents the
highest possible value of the parameter. Setting REVERB MIX to 0 thus results in 0%, while
127 results in 100%.
REVERB-1 & REVERB-2:
Parameter Controller# Parameter Controller#
MIX 10 HICUT 21
INLEV 11 ATT 22
OUTLEV 12 LO-XOVR 23
DECAY 13 HI-XOVR 24
x LOW 14 INITLEV 25
x HIGH 15 REVLEV 26
DIFFUSE 16 I-XFEED 27
SHAPE 17 REVDIFF • 28
x SIZE 18 BUILDUP • 29
PREDLY 19 IATTACK • 30
REVFEED 20 IDECAY • 31
Parameters marked with • are only available in REVERB-2.
REVERB-3:
Parameter Controller# Parameter Controller#
MIX 10 LM-XOVR 19
INLEV 11 HI-XOVR 20
OUTLEV 12 PREDLY 21
DECAY 13 DISTANS 22
x LOW 14 HICUT 23
x LOMID 15 ATT 24
x HIGH 16 MODRATE 25
DIFFUSE 17 MODDPTH 26
LO-XOVR 18 DIFTYPE 27
To Next Page
Loading...
Need help?
General
