TC Electronic M5000 User Manual

MIDI & SMPTE
M5MIDIIN
Rev 1.4 Page 3
PROGRAM CHANGES
When Program Input is enabled (see above), the M5000 will respond to Program Changes
received via MIDI.
If the Program Map is disabled, the M5000 will respond normally to Program Changes (with
regard to the offset, of course). Otherwise, the Program Map must be defined on the following
page:
Program Map Page:
PRG.IN MAPS TO PRESET
PRG.IN MAPS TO PRESET PRG.IN MAPS TO PRESET
PRG.IN MAPS TO PRESET PRG.MAP
PRG.MAPPRG.MAP
PRG.MAP MENU
MENU MENU
MENU
1 no chg.
1 no chg. 1 no chg.
1 no chg. off
offoff
off MIDI
MIDI MIDI
MIDI
The
PRG.IN
knob decides which preset you would like to remap.
The
MAPS TO PRESET
selects which preset will be recalled when the
PRG.IN
preset is recalled. If ‘no chg.’ is selected, nothing will happen when
the
PRG.IN
preset is recalled.
PRG.MAP
enables/disables the program map.
The Program Map can be cleared on the following page:
MIDI Utility-Page:
SELECT FUNCTION PRESS DO
SELECT FUNCTION PRESS DO SELECT FUNCTION PRESS DO
SELECT FUNCTION PRESS DO MENU
MENU MENU
MENU
CLEAR PRG. MAP
CLEAR PRG. MAP CLEAR PRG. MAP
CLEAR PRG. MAP MIDI
MIDI MIDI
MIDI
Turn this knob to select one of the following functions:
CLEAR PRG.MAP
LOAD SETUP FROM CARD
SAVE SETUP TO CARD
LOAD SETUP FROM DISK
SAVE SETUP TO DISK
Press DO to engage the function.

TC Electronic M5000 Specifications

General

Brand	TC Electronic
Model	M5000
Category	Amplifier
Language	English