ALGORITHMS
M5ALGOIN
Rev 1.4 Page 34
DELAY-1 M5000
The DELAY-1 algorithm is basically a simple and easy to handle true stereo digital delay line.
The diagram below is an addition to the signal flow diagram found in the "BASIC ALGO-
RITHMS"-module, page 2.
EDIT PARAMETERS
PAGE 1:
MIX 0 - 100 % Sets the mix between dry and wet signal.
100 % = effect signal only. Mix can be
set to 100 % globally in the G-LEVELS-
menu under UTILITY. Set MIXMODE
WET=MAX
and all dry signals are
"killed" regardless of preset mix settings.
INLEV off - 0.0 dB. Sets the level of the input to the program
in 0.5 dB steps. The function of the
control is to maximize dynamic range.
Please note that this control is positioned
after the input PPM meter, and will not
affect the input PPM reading, also if
using an analog input, make the analog
INLEV adjustment in the G-LEVELS-
menu under UTIL before setting this
control. If the red overload LED flashes,
turn down INLEV a couple of dBs. The
control does not affect the bypassed
To Next Page
Loading...
Need help?
General
