GUIDED TOURS
M5GUIDED
Rev 1.1 Page 3
#2: PROGRAM HANDLING M5000
How do I call up a program:
(GENERAL INSTRUCTION, PROGRAM HANDLING)
1. Press the
PROGRAM
button.
2. Turn knob
A
and choose the Memory Bank
SOURCE
where the program is stored, e.g.
ROM
,
RAM
or
FILE
.
3. Turn the
PROGRAM
knob to choose a program. (The
PROGRAM NUMBER
will blink).
4. Press
DO
. The program is now loaded and the
PROGRAM NUMBER
stops blinking.
How do I edit and store a program ?
(GENERAL INSTRUCTION, PROGRAM HANDLING)
1. Press the
EDIT
button whilst in the program you want to edit.
2. By turning the knobs
A
to
D
and pressing the
PAGE
buttons left or right, all parameters
can be accessed and changed as required. A red LED will appear in the
PROGRAM
NUMBER
display next to the word "
EDITED
" to inform you that parameters in this
program have been changed.
3. Press the
PROGRAM
button.
4. Turn knob
A
until >
>Ram
<< appears.
5. Turn knob
D
until >>
Store
<< appears and choose a new user preset number (RAM) for
the program by turning the
PROGRAM
knob.
6. Press
DO
to store the new program in RAM.
To Next Page
Loading...
Need help?
General
