ALGORITHMS
M5AMBIEN
Rev 1.2 Page 31
reading. There is a separate output level
control for adjusting the analog output
level in UTILITY. Set the analog input
(if you use analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level.
LOWCUT on/off Filters out sub-bass frequencies and any
DC component found in the audio signal.
The filter crossover frequency (-3dB) is
fixed at 2.5Hz and is using a non-
obtrusive 6 dB/oct slope type filter. If
needed, more steep LOWCUT functions
can be found in the eq section.
PAGE 2:
METERS (display) input, output Selects whether the high resolution level
meter is showing input- or output level.
RANGE 18 dB, 36 dB, 72 dB Determines the resolution of the level
meter. The full-scale range is selectable
from 0 dB to either -18, -36 or -72 dB
(see fig. 5-7).
TICKS none, 6, 9 or 12 dB A gradation to the level meter gives a
quick overview of the level status.
HOLD none, max, auto Indicates Peak hold. If set to max or auto
the peak hold either freeze the reached
maximum level or if set to auto it will
hold the peak momentarily.
PAGE 3, LEVEL METER
Fig. 5 The Meter range at 72 dB with the different ticks.
To Next Page
Loading...
