ALGORITHMS
M5ALGOIN
Rev 1.7 Page 33
PAGE 3:
HICUT 500 Hz - flat High cut filter enables you to make the
pitched signal more "warm". This is a 6
dB per octave filter.
ATT -40 - 0.0 dB Gain for HICUT filter. Adjusts in 0.5 dB
steps.
PAGE 4:
DGSPEED 0.05 - 0.5 The de-glitch speed parameter should be
set relatively low for slowly changing
and monophonic source material. Higher
settings are for fast changing and
polyphonic material.
POLYSPD 5 - 50 The polyphonic speed parameter should
be set high for polyphonic and bass type
sources.
POLYDLY 5 - 18 The polyphonic delay parameter control
the response to polyphonic signals.
When this parameter is turned up the
response time will be slower, but the
ability to deglitch polyphonic chords will
be enhanced.
DGFILT 500 Hz, 1 KHz, 2 KHz, This filter is used to determine
and 4 KHz the upper limit of frequencies in your
input signal. The idea is to make the
frequency range, within the pitch shifter,
narrower. This will increase the speed of
the pitch shifting, because the pitch
detector doesn't have to search for so
many frequencies to determine the pitch
of the input signal.
PAGE 5:
MIDIPtc off, on MIDI Pitch Bender control. If this is set
to ‘
on
’ the PITCH-2 algorithm will react
on Pitch Bender control from a MIDI
keyboard.
MIN -1200 - 1200 This determines the minimum key range
value for the Pitch Bender Wheel.
MAX -1200 - 1200 This determines the maximum key range
value for the Pitch Bender Wheel.
To Next Page
Loading...
Need help?
General
