44
8303460000 Rev A IA672-04-01-Rev. I
11.6.2. Read the Hostname
The hostname (see section 4.5) may be read with this query.
Syntax: SYSTem:COMMunicate:LAN:HOST?
Example: SYST:COMM:LAN:HOST?
Response: The hostname string, up to 15 characters long.
Example: GEN500A-339 is a typical factory hostname.
11.6.3. Read the IP Address
The IP address (see section 4.4) may be read with this query.
Syntax: SYSTem:COMMunicate:LAN:IP?
Example: SYST:COMM:LAN:IP?
Response: The IP address string, up to 15 characters long.
Example: 192.168.37.219 is a typical IP address
11.6.4. Read the MAC Address
The MAC address may be read with this query.
Syntax: SYSTem:COMMunicate:LAN:MAC?
Example: SYST:COMM:LAN:MAC?
Response: The MAC address string, 17 characters long.
Example: 00:19:f9:01:24:3b is a typical MAC address
11.6.5. Reset the Hostname and Description
The factory default hostname and description (which is also the DNS service name)
may be reset to factory defaults by entering blanks into the LAN Configure web
page (see section 6.6.2) or by sending this SCPI command:
This command will close any open ports and LAN communication will be lost.
Syntax: DIAGnostic:COMMunicate:LAN:FACtory
Example: DIAG:COMM:LAN:FAC
11.6.6. Reset the LAN Settings
WARNING
Sending this command will disable the
LAN connection to the power supply.
This command will reset the LAN settings to the factory default state. The effect of
this includes closing any open ports and getting the address through DHCP.
Therefore, LAN communication will be lost and your ports will have to be re-opened.
The reset will not restore the factory default hostname and description (see section
11.6.5 above). See section 5.4 for a description of the LAN reset condition.
Syntax: SYSTem:COMMunicate:LAN:RESet
Example: SYST:COMM:LAN:RES
To Next Page
Loading...
