TDK-Lambda GH10-100 - Page 140

129
:CONDition?
:ENABle <NR1> (?)
[:]SYSTem
[:COMMunicate]
:ADDRess <NR1> (?)
:BAUDrate <DSC> (?)
:BOOL <NR1> (?)
:INTerface <DSC> (?)
:LAN
:HOST?
:IDLED <Bool>
:IP <SRD>(?)
:MAC?
:RESet
:LANGuage <DSC> (?)
:WATCHdog
[:STATe] <Bool> (?)
:TIMe <NRf+> (?)
:DATE?
:ERRor:ENABle
:ERRor?
:FRST <DSC>
:FIRMware
[:VERSion]?
:PANel
:LOCK?
:PARallel:ACKNowledge
:PARallel?
:PON
:TIME?
:TIME
:AC?
:PRELoad
[:STATe] <Bool> (?)
:PSOK
:DELay <NRf+> (?)
:RANGe <DSC> (?)
:RIN
[:LEVel] <NRf+> (?)
:STATe <Bool>(?)
:REMote
[:STATe] <DSC> (?)
:SENSe
[:STATe] <DSC>(?)
:SLEW
[:STATe] <DSC>(?)
:TEMPerature
[:AMBient]?
:VERSion?
[:]TRIGger
[:IMMediate]
:DELay <NRf+> (?)
:SOURce <DSC> (?)
Returns the value of the Condition
register
Enables specific bits in the Event
register
Set communication address
Set Baud rate
Set Boolean commands return type
Set communication interface
Read hostname
Blink ID LED & Display
Set IP address
Read MAC address (once)
Set LAN parameters to default
Set communication language
Enable/disable communication
watchdog
Set communication watchdog timeout
Returns system calibration date
Enable error message
Read system error messages
Factory reset/default
Read Firmware versions
Return F.P. lock state
Accept present parallel configuration
Parallel mode
Response total time power ON & power
switch is ON
Response total time from first power ON
Preload ON/OFF
PS_OK delay
Analog programming / monitoring range
Internal resistance value
Internal resistance state
Set the remote/local state
Sense configuration
Set slew state
Measure ambient temperature
Returns SCPI version
Run trigger
Set input trigger delay
Set input trigger source
Reset Fold Back Delay to zero.
Return general status of the power
supply and registers
Return general status of the power
supply
FLT?
FENA(?)
<NC>
<NC>
BOOL
<NC>
<NC>
<NC>
<NC>
<NC>
LANG
SCPI
<NC>
<NC>
DATE?
<NC>
<NC>
FRST
<NC>
<NC>
MS?
<NC>
<NC>
<NC>
<NC>
APR(?)
<NC>
<NC>
RMT(?)
<NC>
<NC>
<NC>
<NC>
<NC>
<NC>
<NC>
FBDRST
STT?
DVC?