TDK-Lambda GH10-100 - default chapter; Table of Contents

TABLE OF CONTENTS
GENERAL INFORMATION .............................................................................................................. 1
CHAPTER 1: FRONT/REAR PANEL CONTROL & CONNECTORS ................................................. 1
1.1 Introduction ............................................................................................................... 1
1.2 Front Panel Controls................................................................................................... 1
1.3 Front Panel Display and Indicators ............................................................................ 5
1.4 Blank Front Panel ....................................................................................................... 7
1.5 Rear Panel Connections and Controls ........................................................................ 8
1.6 J1 Connector Terminal and Function ....................................................................... 10
1.7 Front Panel Display Messages .................................................................................. 12
1.8 Menu Navigation ...................................................................................................... 13
1.8.1 Introduction ................................................................................................ 13
1.8.2 Exiting a Menu ............................................................................................ 18
1.9 Blank Front Panel (GB Series) - Basic Operation ...................................................... 19
1.9.1 USB Driver Installation (PC) ........................................................................ 19
1.9.2 Establish USB Communication .................................................................... 19
1.9.3 Set RS232 Communication Interface (Example) ......................................... 20
1.9.4 Set 9600 Communication Baud Rate (Example) ......................................... 20
1.9.5 Set Power Supply Communication Address (Example) .............................. 20
1.9.6 Set GEN Communication Language (Example) ........................................... 21
1.9.7 Configure to Genesys Power Supply Communication Settings 21
1.9.8 Reset Blank Front Panel Power Supply to Default Settings ........................ 22
CHAPTER 2: LOCAL OPERATION ........................................................................................... 23
2.1 Introduction ............................................................................................................. 23
2.2 Load Connections Options ....................................................................................... 23
2.2.1 Connecting Single Loads, Local Sensing (Default) ...................................... 23
2.2.2 Connecting Single Loads, Remote Sensing ................................................. 24
2.2.3 Connecting Multiple Loads, Radial Distribution Method ........................... 25
2.2.4 Multiple Load Connection with Distribution Terminals ............................. 25
2.3 Constant Voltage Mode and Voltage Setting ........................................................... 26
2.4 Constant Current Mode and Current Setting ........................................................... 27
2.5 Automatic Crossover ................................................................................................ 27
2.6 Output On/Off Control ............................................................................................. 27
2.7 Safe-Start and Auto-Restart Modes ......................................................................... 28
2.8 Viewing Software Revision ....................................................................................... 28
2.9 Alarms and Protective Functions ............................................................................. 28
2.9.1 Introduction ................................................................................................ 28
2.9.2 Over Voltage Protection ............................................................................. 29
2.9.2.1 Resetting the OVP Circuit ............................................................. 29
2.9.2.2 Activated OVP Alarm .................................................................... 30
2.9.3 Under Voltage Protection and Under Voltage Limit ................................... 30
2.9.3.1 Activated UVP Alarm .................................................................... 31
2.9.4 Foldback Protection .................................................................................... 31
2.9.4.1 Activated FOLD Alarm .................................................................. 32
2.9.5 Protection Delay ......................................................................................... 32