TDK-Lambda GH10-100 - Page 25

14
RS232 RS485 USB LANINTFC
0ADR 1 31
9.6K 38.4K 57.6K 115.2 K
BAUD
GENLANG SCPI
G:xx.xxx
REV.
Voltage encoder 1 step rotate
Current encoder 1 step rotate
OPT
--------------------- built_in --------------------- --- optional ---
IP1
0 255
IP4
RESET
1--4
IP
MAC1
MAC6
1--6
MAC
0 255
00 FF
00 FF
LAN
Function (Voltage Display)
Parameter (Current Display)
LAN, MODBUS TCP or
ETHERCAT Interface Active
NO
COMM
ENTER
ENTER
CURRENT
ENCODER
VOLTAGE
ENCODER
6
COMMUNICATION MENU
ENTER
ENTER
Level down
YES
Note: Press Current encoder to select required parameter. Current display blinks - Parameter accepted
For LAN or OPT Interfaces, GEN language is not available
19.2K
SURE
ENTER
LAN, MODBUS
TCP or
ETHERCAT
Interface Not
Active
Voltage encoder multiple steps rotate
Current encoder multiple steps rotate
OFFWD
ON
For GEN language, WD is not available
WD.TIM
WD ON
1 3600
WD OFF
For ETHERCAT Interface, IP is not available
For MODBUS TCP and ETHERCAT Interfaces, OPT is seen instead of LAN
Figure 1–6: COMMUNICATION Menu Diagram