What causes transport lost steps error in tecan sunrise RC Laboratory Equipment?
If the transport system on your Tecan Laboratory Equipment has lost steps, it may be because the optical switch within the transport box is broken, or the plate calibration values have been lost. You can see chapter 4.4.6 Plate calibration Duration Test page 4-16.
What to do if erasing flash block failed on tecan sunrise RC?
If erasing a flash block failed on your Tecan Laboratory Equipment, it indicates a problem with the main board. You can see chapter 8.5 Replacing the Main Board.
How to fix error message on printout cover page of tecan sunrise RC Laboratory Equipment?
If an error message appears on the printout cover page of your Tecan Laboratory Equipment, you can check the filter settings to ensure they correspond with the hardware setting of the filter slide, or try replacing the filter.
What does flash is busy mean on tecan sunrise RC Laboratory Equipment?
If the flash is busy on your Tecan Laboratory Equipment, it indicates a problem with the main board. You can see chapter 8.5 Replacing the Main Board.
What does unexpected flash device mean on Tecan Laboratory Equipment?
If your Tecan Laboratory Equipment displays an 'Unexpected flash device' error, it indicates a problem with the main board. You can see chapter 8.5 Replacing the Main Board.
What to do if filter carriage not defined on tecan sunrise RC Laboratory Equipment?
If the filter carriage is not defined on your Tecan Laboratory Equipment, check the filterslide coding slits.
Why is no data available on my Tecan Laboratory Equipment?
This error is displayed when kinetic measurements got aborted and the instrument is set to Spectra Mode.
What does timeout waiting for measurement finished mean for Tecan Laboratory Equipment?
If you experience a timeout while waiting for a measurement to finish on your Tecan Laboratory Equipment, it suggests an issue with the transport system, possibly related to the transport box or broken optical switches. You can see chapter 7.5 Replacing the Transport Box.
What causes timeout waiting for transport finished in tecan sunrise RC?
If you get a timeout while waiting for transport to finish on your Tecan Laboratory Equipment, it indicates a problem with the transport system, specifically the transport box or broken optical switches. You can see chapter 7.5 Replacing the Transport Box.
Why is the lamp low in my Tecan Laboratory Equipment?
If the lamp is too low on your Tecan Laboratory Equipment, it means there's too little light, which can prevent reliable measurements. You can see chapter 4.4.5 Mirror and lamp adjustment.
Basic safety precautions for instrument use, including warnings and essential guidelines.
Technical details for general specs, variations, options, and accessories.
Information on connecting the instrument to power and safety warnings.
How to install and use the software for firmware updates.
Utility software for instrument adjustment and calibration.
Detailed explanation of how the optical system functions.
Specs, pinout, RS232 lines for computer communication.
Contents and introduction to the service tool kit.
How to install the software included in the service tool kit.
Introduction to the SUNSET software for calibration.
Information on using QC Pac 2 Service for instrument testing.
General components and installation steps for the barcode upgrade.
Procedures for replacing the lamp and various filter carriages.
How to achieve best performance and check instrument accuracy.
Tips on instrument location and operating procedures for best results.
Procedures for checking instrument precision, accuracy, and linearity.
Table of error codes, texts, possible defective parts, and solutions.
General| Brand | tecan |
|---|---|
| Model | sunrise RC |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
