A valid configuration *.json file looks like as follows:
Figure 3-13: ARL table configuration file format
Clear table: All Entries are removed from ARL table. After that, please check the box
“restart after saving” and press the button “save Configuration”
Note: In the current firmware, the saving operation does not working properly
sometimes. After pressing the save button, the shown tabulator jumps to System
Information tab and there is no restart of the MediaGateway. Please go to the Control
Panel-tab and do here the saving again. This way the MediaGateway should restart
and all changes will be saved.
To Next Page
Loading...
Need help?
General