50
Step I: Adding a Thermostat to the Security System
This action can be performed after wireless sensors are installed as described on Step F: Adding Sensors
to the Security System on page 28. You can skip this step and add a thermostat later as described on
page 121.
The Install Zones and Home Devices screen is displayed.
1. Tap Thermostats.
The Locating Thermostat Devices screen is displayed.
2. Tap Next.
The Locating Thermostat Devices screen is displayed.
3. Tap Next.
4. Reset the device to factory default to place it in Search mode.
a. Remove the cover at the top of the thermostat device.
A circuit board is displayed with a black button labeled Reset on the leftward side.
b. Press the Reset button.
The device is reset to factory default.
c. Press the Menu button twice.
d. In the tap screen, press the Mate label twice (below the radio tower icon).
Home System Installation Guide
To Next Page
Loading...
Need help?
General