Installing the Security System
41
The center LED turns on and off as the device boots up. When the LED Left and Center are
on and steady, the iCam is reset to factory defaults and ready to be paired to the
TouchScreen
The Locating Camera screen is displayed. The system locates the camera that is connected to the
TouchScreen’s router with an Ethernet cable, and displays its details.
Figure 34: Camera: Locating Camera Screen
5. Tap Accept to pair the camera with the TouchScreen.
After the system finishes, the Configuring Camera field is marked “Done”. During the Configuring
Camera step, the system upgrades the camera firmware if needed. This can take up to 15
minutes.
Figure 35: Camera: Configuring Camera Screen
6. Tap Next.
The Edit New Camera screen is displayed.
To Next Page
Loading...
Need help?
General