Installing the Security System
75
Step P: Configuring the TouchScreen
If necessary, perform the following operations:
Modify the Entry and Exit delay time periods (see page 85)
Modify the Alarm Transmission delay (see page 86)
Modify the “swinger shutdown” (see page 87)
Reset the TouchScreen to factory defaults (see page 87)
Note: This causes the device to require activation again, which in turn requires that the customer’s
account be reset as well.
Check for a new firmware update (see page 90)
Manage the sensors/security zones (see Table 6: Sensor Operations on page 76)
Manage the cameras (see Table 7: Manage Camera Operations on page 77)
Manage key fobs and key pads (see Table 8: Manage Peripheral Operations on page 77)
Manage lights and thermostats (see Table 9: Manage Environmental Device Operations on page
78)
Technicians also can perform the following general activities that are available to the customer.
Note: See the TouchScreen User's Guide for information about these activities.
Manage the way sensors are listed in TouchScreen reports and tools
View and test the TouchScreen’s connectivity to the central monitoring stations
Manage the keypad codes and secret word
View the customer’s account information
Manage your TouchScreen device sounds, screensaver, etc.
View technical information about the TouchScreen device
To Next Page
Loading...
Need help?
General