JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 9.6
9.1.14. ENABLE UP/DOWN MOTOR
This parameter enables or disables use of the machine incline. To change the selection, when the
LED matrix shows the current setting:
UP-DOWN: xxx
Press the +/- GOAL keys to select the desired option out of those listed in the table below:
UP-DOWN
ENABLED <default>
DISABLED
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or previous
parameter.
9.1.15. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the LED matrix shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or preceding
parameter. If the ENTER key is pressed the LED matrix will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
9.1.16. FORMAT P&P
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
LED matrix shows:
FORMAT P&P
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or preceding
parameter.
At the end of the format procedure, hold down the CLEAR key for a few seconds to exit. The
CLEAR key can be pressed at any time to interrupt the procedure and revert to standby mode.
9.1.17. USER DETECT
This function is able to detect the presence of a user running on the tread belt during an exercise
session. It is possible to configure a minimum speed at which the machine will determine that the
user has stopped running on the treadmill, and interrupt the exercise session if the condition persists
for one minute. To change the setting, when the LED matrix shows the current duration:
USER DETECT: xxx
To Next Page
Loading...
