JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 7.10
7.9. DISASSEMBLING THE MOTOR GUARD
Figure 7.9-1
Turn off the machine and unplug the mains lead
from the wall outlet.
1. If possible, lift up the machine at the
elevation of 10%, to make the procedure
easier.
2. Back off the 6 screws a, using a 4-mm hex
wrench.
3. Remove the motor casing pulling it out from
the front side of the machine.
To reassemble the motor guard, carry out the
above steps in reverse order.
To Next Page
Loading...
