Technogym JOG EXCITE - Smontaggio Maniglioni

JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 7.9
7.8. SMONTAGGIO MANIGLIONI
Figure 7.8-1
Carry out the procedure described in paragraph
7.1. “Disassembling the display”.
1. Back off the 2 screws a using a m
edium
Phillips screwdriver.
2. Remove the handlebar pulling it out from the
rear side.
Figure 7.8-2
To disassemble the central handlebar:
3. Carry out the procedure described in
paragraph 7.1. “Disassembling the display”.
4. Back off the 8 screws b using a medium
Phillips screwdriver.
5.
Figure 7.8-3
6. Back off the 2 screws c using a 6-mm hex
wrench.
7. Remove the handlebar taking care of the
cable coming from the hand sensor.
To reassemble the handlebars, carry out the
above steps in reverse order.