JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 8.1
8. ADJUSTMENTS
8.1. TENSIONING A NEW TREAD BELT
Figure 8.1-1
1. After replacing the tread belt, place a tape
measure along the centre of the tread belt and
use a pen to make two reference marks
spaced exactly 1 meter apart.
Figure 8.1-2
2. Lock down by turns the screws a until the
distance between the reference marks
increases by 7 mm. Take care that the roller
is always approximately parallel with the one
on the front, to counteract the tension exerted
by the belt on the roller bearings.
After completing this procedure, any
further adjustments should be
performed using only the left-hand
alignment screw.
After completing this procedure, check
the centering of the tread belt as
instructed in paragraph 8.3. .
To Next Page
Loading...
