Technogym JOG EXCITE - Disassembling the Electrical Box

JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 7.13
7.12. DISASSEMBLING THE ELECTRICAL BOX
Figure 7.12-1
Carry out the procedure described in paragraph
7.9. “Disassembling the motor guard”.
1. Back off the screws a using a medium
Phillips screwdriver.
2. Disconnect the cables entering the electrical
box:
• Power supply cable from the power
supply box;
• Cable connecting upper and lower
assemblies;
• Limit switch cable;
• Ground connection cable;
• Fan cable;
• Tread belt motor cable;
• Elevation motor cable (TRM-08).
3. Remove the entire box from its compartment
in the machine.
To reassemble the electrical box, carry out the
above steps in reverse order.