JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 7.17
7.15. DISASSEMBLING THE TREAD BELT MOTOR
Figure 7.15-1
Carry out the procedure described in paragraph
7.9. “Disassembling the motor guard”.
1. Release the spring a of the tensioning
mechanism between the drive-belt and the
front roller of the tread belt.
Figure 7.15-2
2. Unplug connector of the tread belt motor
cable on the AT driver.
3. Use a 13-mm wrench to back off the 4 nuts b
locking down the screws on the lower side
with a 6-mm hex wrench.
4. Remove from the machine the plate on which
is mounted the tread belt motor and
disassemble it.
To reassemble the tread belt motor, carry out the
above steps in reverse order.
To Next Page
Loading...
