Technogym JOG EXCITE - Distance; Maximum Exercise Time; Pause Time

JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 9.2
LANGUAGE : xxx
Press the +/- GOAL keys to select the desired language from the options available. Press ENTER
to confirm the choice, use the + or – speed keys to move to the next or previous parameter.
9.1.2. DISTANCE
It is possible to choose between EUROPEAN units (kg and km) or IMPERIAL units (pounds and
miles). To change the selection, when the LED matrix shows the current setting:
DISTANCE : xxx
Press the +/- GOAL keys to select the desired unit of measurement from the options listed in the
table below:
DISTANCE
KM <default>
MLS
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.3. MAXIMUM EXERCISE TIME
It is possible to set a maximum duration for the exercise in minutes, with values ranging from 1 to
9999. To change the setting, when the LED matrix shows the current maximum time limit:
MAX TIME: xxx
Press the ENTER key to modify the parameter: when the current value of the parameter starts to
blink, press the CLEAR key to erase the current value and then enter one digit at a time using the ↑
and ↓ keys to change the value and the +/- GOAL keys to scroll to the next character.
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
The default value of this parameter is 9999.
9.1.4. PAUSE TIME
It is possible to set a maximum duration of the pause for every exercise in seconds, with values
ranging from 10 to 999. To change the setting, when the LED matrix shows the current maximum
pause time:
PAUSE TIME : xxx
Press the ENTER key to change the parameter: the current value of the parameter will start to
blink, at this point press the CLEAR key to erase the current value and then enter one digit at a
time using the ↑ and ↓ keys to change the value and the +/- GOAL keys to scroll to the next
character.
Press ENTER to confirm the changes made, and use the + or – speed keys to move to the next or
preceding parameter.
The default value of this parameter is 60.