Technogym JOG EXCITE - DEFAULT CALORIES: XXX; Default Distance; Enable TGS

JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 9.4
9.1.8. DEFAULT CALORIES
It is possible to set the calories for every exercise, with values ranging from 10 to 999. To change
the setting, when the LED matrix shows the current setting:
DEFAULT CALORIES : xxx
Press the ENTER key to change the parameter: the current value of the parameter will start to
blink, at this point press the CLEAR key to erase the current value and then enter one digit at a
time using the ↑ and ↓ keys to change the value and the +/- GOAL keys to scroll to the next
character.
Press ENTER to confirm the changes made, and use the + or – speed keys to move to the next or
preceding parameter.
The default value of this parameter is 300.
9.1.9. DEFAULT DISTANCE
It is possible to set the distance for every exercise in Km, with values ranging from 1 to 999. To
change the setting, when the LED matrix shows the current setting:
DEFAULT DISTANCE : KM xxx
Press the ENTER key to change the parameter: the current value of the parameter will start to
blink, at this point press the CLEAR key to erase the current value and then enter one digit at a
time using the ↑ and ↓ keys to change the value and the +/- GOAL keys to scroll to the next
character.
Press ENTER to confirm the changes made, and use the + or – speed keys to move to the next or
preceding parameter.
The default value of this parameter is 10.
9.1.10. ENABLE TGS
It is possible to enable or disable the use of the TGS reader. To change the selection, when the LED
matrix shows the current setting:
TGS: xxx
Press the +/- GOAL keys to select the desired option from those listed in the table below:
TGS
ENABLED <default>
DISABLED
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.