Technogym JOG EXCITE - Disassembling the Circuit Boards of the Display

JOG EXCITE: Service & Maintenance Manual - rev. 1.1
Page 7.2
7.2. DISASSEMBLING THE CIRCUIT BOARDS OF THE
DISPLAY
Figure 7.2-1
Carry out the procedure described in paragraph
7.1. “Disassembling the display”.
1. Place the display on a work bench.
2. Unplug the connector indicated in the figure.
3. Back off the 5 screws a using a small Phillips
screwdriver.
4. Remove the circuit board.
To reassemble the circuit boards, carry out the
above steps in reverse order.
After the reassembling of the board,
remember to fix the keyboard connector
using a drop of hot glue.