KINESIS ONE: Service & Maintenance Manual rev. 2.1
Page 6.12
Figure 6.4-10
9. Pass the cable through the tension adjusting
pulley (f), then pass it through the hole in the
front panel, as shown in figure.
CAUTION: It is important to pass the
cable inside the anti-slip off device, so
that the cable can not get out of the
pulleys during the exercise
Mount all the handles on the cable so that the Technogym® logo, is readable by the user,
in operating position.
Figure 6.4-11
Continued on following page
→
To Next Page
Loading...
