Tecnoware EVO DSP PLUS MODULAR - Page 101

ENGLISH
UPS EVO DSP PLUS Modular 95 User’s manual
LCD Message
Explanation
Solution
Warning! Fan Lock
As stated,
Check if the fan is blocked or contact service
personnel.
Warning! Line Phase Error
As stated,
Check if the Mains phase sequence is correct and
contact service personnel.
Warning! Bypass Phase Error
As stated,
Check if the Bypass phase sequence is correct
and contact service personnel.
Warning! N Loss
Neutral loss
Check if the Neutral connection is well and
contact service personnel.
Warning! Internal Initial Fail
As stated,
Contact service personnel.
Warning! Comm. Syn. Signal
Fail
Communicate Synchronization Signal Fail
Contact service personnel.
Warning! Comm. TRIG0 Fail
Communicate Trigger signal fault
Contact service personnel.
Warning! Redundancy Set Fail
As stated,
Check if the redundancy setting is correct and
contact service personnel.
Warning! Parallel Sys Config.
Wrong
Parallel System Configure error
Contact service personnel.
Warning! Maintenance Bypass
Enter maintenance
Check if the mechanical lock plate of
Maintenance Bypass switch is not loose
Warning! Battery Age Alert
Battery Life expiration
Check if the Battery has been used over its
service age. Or contact service personnel.
Warning! Parallel UPS Cable
Loosen
As stated,
Check if the Parallel UPS Cable is loose and
contact service personnel.
Warning! Parallel UPS Config.
Wrong
Parallel UPS Configure error
Check if the Parallel UPS Setting is correct and
contact service personnel.
Warning! Parallel Firmware
Error
Power Stage parallel firmware error
The firmware version does not support UPS
Parallel feature. Contact service personnel.
Warning! ID Conflict
Power Stage ID conflict
There are two Power Modules with the same ID
numbers. Change the repeated ID to release it.
Or contact service personnel.
If the described anomalies should continue despite the advised troubleshooting, or should they
manifest in any other form, please contact:
TECNOWARE SERVICE
www.tecnoware.com