3.6.3. STRING Record
To measure in String mode, write String Lst of the batteries to be measured.
Refer Record explanation.
[String Mode measurement ]
Press button to display Impedance ①
Press button to select
. ②
Press
.
③
String list is displayed (To make String, refer explanation of Record Function) ④
Press
,
to select String ⑤
Press
to select String. ⑥
indicates of slot of measurements of selected String ⑦
Press
,
to select slot of New measurement or next slot of ⑧
existing measurement
Press
to complete String Select
⑨
is ON and ready to measure. Check whether Cell number is same as Battery ⑩
to be measured. If not same, press
to move Cursor.
Contact Test Probe to Battery terminal. For correct 4 terminal measurement, press both ⑪
inside and outside Probe Pin to contact both side to the Battery Terminal .
activates to hold and save . ⑫
Continue to measure on rest cells. ⑬
To Next Page
