Tektronix AFG31000 Series

Function introduction
AFG31000 Series Arbitrary Function Generator User's Manual 127
Input and output interface
The I/O (input and output) Interface options in the Utility menu are listed below. This feature is used to
connect your instrument to a network.
NOTE. You must obtain information from your network administrator to accomplish these settings. The
procedure for entering the network settings depends on your network configuration.
 Configuration: Select Off Bus (to disconnect your instrument from the GPIB bus) or
Talk/Listen (to remotely control your instrument from an external host computer. See
Connect to a network for more information.
 GPIB Address: Enter the address of your instrument.
 DHCP: Select On or Off for the dynamic host configuration protocol (this option is
network-dependent).
 Default Gateway: Select the dialog box and enter the gateway address (your network
administrator can provide this information).
 Subnet Mask: Enter the subnet mask (your network administrator can provide this
information).
 IP Address: Enter the correct IP address.
Figure 121: I/O Interface options