MX32v2
ANALOG AND DIGITAL CONTROLLER
USER MANUAL
Revision D.0
This symbol denotes:
Attention! In the present mode of use, failure to adhere to
the instructions preceded by this symbol can result in a risk of electric shock
and/or death.
This symbol indicates: You must refer to the instructions.
European Union (and EEA) only. This symbol indicates that this product must not
be discarded with household waste, as per the EEA directive (2002/96/EC) and
your own national regulations.
This product must be disposed of at a collection point that is reserved for this
purpose, for example, an official site for the collection of electrical and electronic
equipment (EEE) in view of their recycling, or a point of exchange for authorized
products that is accessible when you acquire a new product of the same type.
1.3 Safety Instructions
Labels intended to remind you of the principal precautions of use have been placed on the unit
in the form of pictograms. These labels are considered an integral part of the unit. If a label falls
off or becomes illegible, please ensure it is replaced. The significance of the labels is detailed
below.
The installation and electrical connections must be carried out by qualified personnel
according to the instructions of the manufacturer and the standards of the competent
authorities.Failure to adhere to the instructions can have serious consequences on the
safety of persons. Please be extremely rigorous as regards electricity and assembly
(coupling, network connections).
Cables with an operating temperature of 70°C minimum (158 °F)
because the temperature inside the controller can reach 70°C (158 °F).
1.4 Important Information
The modification of the material and the use of parts of an unspecified origin shall entail the
cancellation of any form of warranty.The use of the unit has been projected for the applications
specified in the technical characteristics. Exceeding the indicated values cannot in any case be
authorized.
To Next Page
Loading...