MX32v2
ANALOG AND DIGITAL CONTROLLER
USER MANUAL
Revision D.0
9 Cleaning and maintenance
9.1 Cleaning
Do not use alcohol- or ammonia-based liquids to clean the controller. If necessary, clean the
exterior of the enclosure with a damp cloth.
9.2 Fuse replacement
Fuse replacement should only be performed by qualified personnel and power must
be first switched off.
Fuses shall comply with IEC 60127 standard (time-delay fuse, low breaking capacity,
250Vac). Please see 0.
9.3 Replacement of the lithium battery
Lithium battery replacement should only be performed by qualified personnel and with an
identical battery (see Chapter 8 for the list of spare parts). The controller must be first switched
off. Power on the controller once the battery has been replaced.
TELEDYNE OLDHAM SIMTRONICS does not allow any other repairs than those
listed here above.
Burn hazard. As the temperature inside the controller can reach 70°C (158 °F), it
should be allowed to cool after aperture.
To Next Page
Loading...