ST Series Power Supply Instruction Manual INTRODUCTION
telemark.com 13 of 64 Rev 1.0.0
Use decals or other warning labels on the High
Voltage shield, at the front of the E-beam chamber
and on the door(s) to the room(s) housing the
chamber and power supply to provide a warning that
lethal voltages are present.
Do not put any part of the body under a chamber
while a source is running.
Always use a grounding hook as a matter of habit
before touching any potentially High Voltage area,
even when the power supply is off.
Always keep one hand in a pocket.
Always maintain a respectful fear of high voltages:
familiarity does not make high voltages safe.
To Next Page
