ST Series Power Supply Instruction Manual INSTALLATION
telemark.com 23 of 64 Rev 1.0.0
3 INSTALLATION
3.1 UNPACKING
1. Before unpacking, visually inspect the transport packaging for signs of external
damage.
2. Unpack the ST Power Supply components and place the packaging material aside.
NOTE: Keep the packaging material for future use! The ST Power Supply
must be stored and transported in the original packaging material only.
3. Examine the contents and verify that all components, cables, and accessories are
present. (See Figure 3-1, ST Power Supply Component List and Figure 3-3, Cable Kit
Components.)
4. Visually inspect the ST Power Supply for any signs of damage.
Never Power Damaged Product.
Putting a damaged product into operation can be
extremely dangerous.
Never attempt to put a damaged product into
operation. Secure the damaged product from
unintended operation. Send a damage report to the
transport company or the insurer.
To Next Page
