ST Series Power Supply Instruction Manual INTRODUCTION
telemark.com 9 of 64 Rev 1.0.0
operation directly and control High Voltage and Emission output without having to move
back and forth to the ST Controller installed in the instrument rack.
1.4 LIABILITIES AND WARRANTY
Telemark is not liable for damages resulting from improper use of the device and any
guarantees expire, if the user, or a third party:
• ignores information contained in this manual
• utilizes the product in a manner inconsistent with the intended purpose
• makes any modification or alteration to the product
• uses any unauthorized accessories with the product
Telemark reserves the right to make changes without prior notice.
1.5 SAFETY
Telemark is concerned for your general welfare and safety. Please follow these safety
guidelines below to ensure you have a safe and productive operation of your ST Power
Supply.
1.5.1 Personnel Qualifications
All work described in this document may only be carried out by persons who have
suitable technical training and the necessary experience.
1.5.2 General Safety Instructions
For all work performed on this product, be sure to adhere to all the applicable safety
regulations and local and regional Electrical Codes. Observe all safety notices given in
this documentation and forward this information to all other users of the product.
1.5.3 Illustrations of Risks and Hazards
This Instruction Manual illustrates safety notes concerning risks and hazards as follows:
Indicates important information that must be adhered to.
Indicates risk of exposure to electrically energized components.
To Next Page
Loading...