ST Series Power Supply Instruction Manual REMOTE OPERATION
telemark.com 48 of 64 Rev 1.0.0
NOTE: For safety reasons the OFF pushbuttons, both HV and Source,
are always enabled regardless of the Control mode selection.
J4 also provides several status and analog signal feedbacks to the
Process Controller for complete process control. See Chapter 9: Figure
9-3, J4 Remote User I/O Connector and Figure 9-4, J4 Remote User I/O
Connector for more details.
5.1 REMOTE USER I/O PINOUTS
J4 – REMOTE USER I/O (Sub-D 37pin), see also Figures 9-3 and 9-4
To Next Page
