Teleste MPH241 - CLI License, Version, Firmware, Config Commands

80 MPH200 series video encoders CLI user manual
swversion
Description:
Prints the current software version
swud <tftp link>
Description:
Downloads software image from tftp and update. Device will
reboot once the software image is downloaded successfully
<tftp link>: String of upto 128 characters with tftp://<ip_
address>/software_image format
Example:
swud tftp://192.168.36.148/tvelightimage.bin
getconf <-ip=server_ip> <-file=config_file_name>
Description:
Download configuration file from tftp server and restore
configurations. Device will reboot once the file is downloaded
successfully
Example:
getconf -ip=192.168.36.148 -file=tve.cfg
putconf <-ip=server_ip> <-file=config_file_name>
Description:
Upload configuration file to tftp server for backup. The file
name can be chosen by the user
Example:
putconf -ip=192.168.36.148 -file=tve.cfg
licenseupdate [<license_key>]
Description:
Update product license key. The license key will be validated
against device serial number before updating. The device
will reboot after successfully updating the license key. If
the licensekey is not provided, this command will print the
current license key
[<license_key>]: Product license key string. If this string is
not provided, current license key will be displayed
Example:
licenseupdate MPH-1A-E1CGAX-AXXAXXOX-
XXXXXXXX,HL00000000,0,EJPKOJ-XLJAYA-I72CA2
Entering help swversion displays information about
the swversion command:
Entering help swud displays information about the swud command:
Entering help getconf displays information about the getconf command:
Entering help putconf displays information about the putconf command:
Entering help licenseupdate displays information about
the licenseupdate command:
Use the licenseupdate command to
activate a new licence to the device.
Use the swversion command to
view the current rmware version of
the device.
Use the swud command to change
device’s rmware.
Use the getconf command to
download stored conguration from
a TFTP - server.
Use the putconf command to
upload the current conguration to
a TFTP - server.