wireless system is connected to a central unit
and PC control software is used.
While the conference unit is in request, the red
signal ring of the microphone will flash.
Direct Access:
Enables the participant to turn on or off his
microphone at any time. The only limitation here
is the maximum number of microphones that
may be active simultaneously.
FIFO:
In this conference mode, only one microphone
can be active at a time without intervention of
the conference operator. Activation of another
microphone switches off the current active
microphone.
The only exception here is that the chairman
microphone can always be activated..
Override:
Works like the FIFO mode; however multiple
microphones can be active at the same time. The
number of microphones that can be active
simultaneously is set by "Maximum Number of
active Microphones" setting.
When the maximum allowed number of
microphones are switched on, activation of an
additional microphone will automatically switch
off the microphone that was active for the
longest time. Again, the Chairmen units can
always be activated, regardless of the number of
microphones already switched on.
Group 1:
Enables one microphone at a time to be active
without a request for activation. Other
participants can switch their microphone in
request mode; the first applicant gets the floor
when the delegate who has the floor turns off
his active microphone or when the chairman or
conference operator grants the participant the
permission to talk by using the NEXT button or
by clicking the green microphone on the
computer screen.
Group 2:
Enables two microphones to be active at the
same time. Other participants can switch their
microphone in request mode; the first applicant
who requested the floor gets the floor when one
of the currently active microphones is turned off
or when the chairman or conference operator
grants the participant the permission to talk.
Group 3:
Works the same way as Group 1 and Group 2,
with the alteration that three participants can
have the floor at the same time.
Group 4:
Works exactly like Group 1 and Group 2, with
the alteration that four participants can have the
floor at the same time.
Note:
The setting Maximum Number of Active
Microphones has priority over the group
setting , so regardless the chosen group
setting , the number of participants that
can have the floor at the same time is
always limited by the Maximum Number
of Active Microphones setting.
To Next Page
Loading...
